Yayın: An experimental investigation on effect of cutting fluids in turning with coated carbides tool
Dosyalar
Tarih
Kurum Yazarları
Işık, Yahya
Yazarlar
Danışman
Dil
Türü
Yayıncı:
Association of Mechanical Engineers Technicians Slovenia
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Özet
The major needs in machining are high material removal rate, good work surface finish and low tool wear. These objectives can be achieved by reducing tool wear using proper cooling system of the tool during machining. The work aims to seek conditions in which dry cutting is satisfactory compared with the,flood of fluid usually used. The cutting tool used in this research is CVD coated carbide TiC+Al2O3+TiN insert (ISO P25). The type of inserts is DNMG 150608. During the experiments flank wear, cutting force and surface roughness value were measured throughout the tool life. The results have been compared with dry and wet-cooled turning. The results of the present work indicate substantial reduction in tool wear, which enhanced the tool life; this may be mainly attributed to reduction in cutting zone temperature and favorable change in the chip-tool interaction.
Açıklama
Kaynak:
Anahtar Kelimeler:
Konusu
Flank wear, Tool life, Cooling, Cutting forces, Tool wear, Surface-roughness, Flank wear, Steel, Performance, Life, Engineering, Chemical vapor deposition, Cooling systems, Surface roughness, Titanium carbide, Titanium nitride, Turning, Wear of materials, Cutting forces, Cutting zone, Dry and wet, Dry cutting, Experimental investigations, Flank wear, Material removal rate, Substantial reduction, Surface finishes, Tool life, Tool wear, Cutting fluids
Alıntı
Işık, Y. (2010). "An experimental investigation on effect of cutting fluids in turning with coated carbides tool". Strojniski Vestnik/Journal of Mechanical Engineering, 56(3), 195-201.