Eşiyok, FerdiErtan, RukiyeSevilgen, GökhanBulut, EmreÖzturk, FerruhAlyay, İlhanAbi, Tuğçe Turan2024-09-232024-09-232022-08-011059-9495https://doi.org/10.1007/s11665-022-07167-8https://link.springer.com/article/10.1007/s11665-022-07167-8https://hdl.handle.net/11452/45033In this paper, the conventional hot forming and hybrid quenching hot forming processes of Al-Si-coated 22MnB5 steel sheet were investigated and compared at 0.5 s-15 s holding times in the press tool related to the mechanical properties, microstructure, and dimensional accuracy. The conventional hot forming method is classified as a direct method and an indirect method. Both methods have limitations due to processing time and cooling of the press tool. To speed up the process, an alternative cooling method based on spray or jet cooling was used outside of the die tool. The hybrid quenching method involves hot forming and spray cooling process. This method, using spray parameters, provides more effective control in mechanical properties and microstructure compared to the conventional method by using spray parameters. Vickers hardness tests and tensile tests were carried out to compare mechanical properties. Changes in the microstructure of the materials were investigated using an optical microscope. The results show that spray cooling can be used as part of quenching in the hot forming process by reducing the holding time in the press tool by 97%. However, the microstructure, mechanical properties, and geometry deviations of the stamped parts are still below tolerances after the hybrid quenching hot forming process. The use of the hybrid quenching method with multi-point nozzles in the hot forming process resulted in sheet hardness up to 470 HV1 and 8% elongation with tensile strength of 1500 MPa.eninfo:eu-repo/semantics/closedAccessHeat-transfer coefficientStamped b-pillarPredictionCrackingLoad22mnb5Dimensional accuracyHot formingMicrostructureMechanical propertiesSpray coolingMaterials scienceArticle0008347288000031347135632310.1007/s11665-022-07167-8